Anti stone-chip coatings

Multifuller UBS anti-gravel coating spray, spray can total volume 500 ml. Forms a strong and elastic coating that protects against mechanical damage. Used on visible parts that need additional protection. Available in white, gray and black. Must be over sprayed with paint or clearcoat.  It is recommended to wear protective clothing and goggles during painting.  Apply 2-3 thin coats to the surface. Allow each coat to dry for 3-5 minutes, but no longer than 30 minutes. After use, to clean the nozzle, turn the spray upside down and spray until only compressed air comes out of the spray. After ~1.5H of drying, cover with a base or acrylic paint in the appropriate shade, must be over sprayed. Multifuller UBS antigravel Coating Product Description and Technical Data Sheet in English

Read more less

CAR-REP Stone Chip spray 500 ml is a 1k anti-chipping coating for visible parts that need additional protection. Available in white, gray and black. Must be overpainted or added as . CAR-REP Stone chip spray application guide The surface to be painted must be clean, degreased and dry - either primed or if existing, previous paint layer matted. Make sure you protect adjacent surfaces that will not be painted by covering/masking them. Shake the bottle for at least 2 minutes, even after the mixing beads have separated from the bottom of the bottle, and also occasionally during painting. During painting, hold the bottle in a vertical position, approximately 30 cm from the surface to be painted. Apply 2-3 thin coats to the surface, allow each coat to dry for 3-5 minutes, but no longer than 30 minutes. To clean the nozzle, turn the spray upside down and spray until only compressed air comes out of the bottle, so the spray can be reused.

Read more less

Radex 310 SP is a sprayable anti-stone chip protective mastic made of synthetic rubber and resins in a 1l bottle supposed to be used with anti-gravel spray guns. Available in black, grey and white. Quickly creates a structured protective coating (usually on sills and on the wheel arches, locations where a painted protective layer is necessary. Must have a paint or clearcoat layer applied over it to have full protection capabilities. 

Read more less

Mercasol 2 is a solvent-based transparent anti-corrosion protection product that leaves a completely dry and non-sticky surface. Based on wax and sulfonates, provides long-term protective properties. Mercasol 2 is mainly used on visible surfaces where a dry, non-tacky, discreet protective layer is required, for example on vehicle doors and hoods, or on tools and equipment. Mercasol 2 can also be used as anti-corrosion protection in joints and connection points. Mercasol 2 application suggestions The surfaces to be treated must be dry and free from rust, dirt, salt, and oil. Application should be carried out indoors at a temperature between +15°C and +25°C. Mercasol 2 1-liter bottle is intended for use with a compressed air spray gun together with a cavity hose. Mercasol 2 aerosol is applied using the attached nozzle and tube. When applying with an aerosol, two coats may be required to achieve the recommended dry film thickness, as the applied layer is finer compared to spraying with a gun. Mercasol 2 technical data sheet in English.

Read more less